How to measure Blood pressure monitor accurately?
To measure your blood pressure monitor accurately with Spinegear CK-W358.
Follow this guide below:
Quick guide on some settings from Spinegear CK-W358
Â
 How to turn the Speaker OFF:
1. Press Start/stop button to turn on or off the device at anytime
2. While the device is turned off, Press SET and hold for 5 seconds
3. Use MEM button to select the user you want to configure, use SET to acknowledge
4. Use MEM to select the year and use SET to acknowledge until you get to SP ON/Off Use MEM to select either you want the Speaker on or off and use SET to acknowledge
5. Set your alarm for daily same-time monitoring using the same setting. Alarm 1 and 2 For more info refer to page 10-12 of the manual.
Â
How to Check stored Memories
1. While the device is turned off Press MEM button
2. Keep pressing MEM button to navigate each reading until 90 Memories.
Note: •
Use 5V 1A charger (Phone charger, Laptop/PC port, Power pack etc)
• The device is set to turn off automatically. You do not need to switch it off, it turns off itself and doesn't exhaust power.
• You only switch it off behind when you need to reset the date and time, but your data remains intact.
Spinegear Posture Corrector for Men and Women (SP-MXF4)
Spinegear Rechargeable Blood Pressure Monitor 3 colour Backlight LCD
Good Morning,
I purchased one of your Blood Pressure Monitors via Amazon that was delivered on Saturday 15 Jukly after only placed my order the day before, very speedy delivery.
My problem with your CK-W358 is I cannot set the date and time. Pressing the Set button brings yup the numerals in the bottom left hand corner, but there is no way I have been able to change the numbers that appear despite following your written instructions, pressing the Mem button as suggested just brings up my last measurement.
Is this unit faulty and if so how do I remedy the fault or is it necessary to return the unit and make a complaint via Amazon or Trustpilot?
Dear David,
Thank you for your patronage.
Press Start/stop button to turn on or off the device at anytime
While the device is turned off, Press SET and hold for 5 seconds
Use MEM button to select the user you want to configure, use SET to acknowledge
Use MEM to select the year and use SET to acknowledge
Continue to use MEM to select and SET to acknowledge.
Refer to page 10 of the manual for more details
Note:
ï‚· The device is set to turn off automatically. You do not need to switch it off; it turns off itself
and doesn’t exhaust power.
ï‚· You only switch it off at the side when you need to reset the date and time, but your data will remain intact.
Kindly follow the instructions in the manual when using the device for an accurate result.
Thank you
Regards
Nicole
Hi
I purchased the Arm type electronic blood pressure monitor model CK-A138 about 12 months ago via Amazon. It worked twice this morning one after another, i attempted to use it for a third time, the display is working but the arm isn’t filling up with air. Any ideas as to what could be wrong?
Dear Rachel,
Please inspect the cuff because the cuff hose could be leaking.
If it’s leaking you will need to get another upper arm cuff and the device will start working back.
Thanks
Nicole
Hi Nicole
It does not blow any air into the cuff at all, my partner has checked it. The unit will just not blow any air out whatsoever.
Thankyou
Rachel